Filter
Top Products
26
RQT804
RQTX1097
ESPAÑOLESPAÑOLESPAÑOLESPAÑOLESPAÑOL
■ USB Page
The USB drive or its
contents cannot be
read.
• The USB drive format or its contents is/are not compatible with the
system.
• The USB host function of this product may not work with some USB
devices.
• USB devices with storage capacity of more than 32 gigabytes may not
work in some instances.
20
—
—
Slow operation of the
USB device.
• Large fi le size or high memory USB fl ash drive takes longer time to
read.
—
■ Unit displays
“NO PLAY”
• Check the content.
• Only MP3 format fi les can be played.
—
—
“F61”
• Check and correct the speaker cords connection.
If this does not fi x the problem, consult the dealer.
• Disconnect the USB device. Turn the unit off and then turn back on.
7
—
“ERROR”
• Incorrect operation performed. Read the instructions and try again. —
“ERROR” (during
recording)
• You are not able to select other playback source (example: radio, USB
and etc.) or press [2/3] or [5/6] during recording.
Stop the recording function.
• You are not able to open the disc tray when recording from AM source.
• Select a suitable recording mode (128 KBPS or 192 KBPS) and resume
recording.
16
—
19
“PLAYERROR”
• An unsupported MP3 format is being played. The unit will skip that track
and play the next one.
—
“VBR–”
• The unit cannot display the remaining play time for variable bit rate
(VBR) tracks.
—
“HI-SPEED CAN’T REC”
• You cannot use high-speed recording while using analogue mode.
Change to digital mode or use normal recording.
19
“DEVICE FULL”
• You cannot perform recording because the total USB remaining REC
(recording) time of the USB device is less than the total time of the
music source.
Change to a USB device which has the appropriate recording time and
perform the recording again.
15
System memory reset (Initialisation)
When the following situations occur, refer to the instructions below to reset the memory:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
To reset system memory
1 Disconnect the AC mains lead. (Wait at least 3 minutes before proceeding to step 2.)
2 While pressing and holding down [1] on the main unit, reconnect the AC mains lead.
“– – – – – – – –” appears on the display panel.
3 Release [1 ].
All the settings are returned to the factory preset.
You will need to reset the memory items.
Maintenance
If the surfaces are dirty
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
AKX50_EB_EN.indd 26AKX50_EB_EN.indd 26 6/8/2010 5:25:28 PM6/8/2010 5:25:28 PM