Filter
Top Products
12
RQT7923
Setting the clockSetting the clock
This is a 12-hour clock.
1
Press [CLOCK/TIMER] to select “CLOCK”.
Each time you press the button:
CLOCK
˚ PLAY
Original display
˚ REC
2
Within 5 seconds, press [4/REW/4] or
[3/FF/¢] to set the time.
3
Press [CLOCK/TIMER] again to confirm.
Displaying the clock
Press [CLOCK/TIMER] to display the clock for few seconds.
• The clock may lose or gain some time over a period. Readjust if
necessary.
Using the sleep timerUsing the sleep timer
This function enables you to turn off the unit automatically
after the set time.
Press [SLEEP] to select your desired time.
SLEEP 30 SLEEP 60 SLEEP 90
SLEEP 120SLEEP OFF
Sleep timer indicator
To cancel
Press [SLEEP] to select “SLEEP OFF”.
Changing the remaining time
Press [SLEEP] to show the time and press [SLEEP] again to
select your desired time.
• The play and sleep timer or the record and sleep timer can be used
together.
• The sleep timer always has priority. Be sure not to overlap timer
settings.
Using the play or record timerUsing the play or record timer
You can set the timer to come on at a certain time to wake
you up (play timer) or to record from the radio or an aux
source (record timer).
Turn the unit on and set the clock.
Timer Action
Play timer Prepare the music source you want to listen to;
tape, CD number (1~5), radio or AUX, and set the
volume.
Record timer
Check the cassette’s erasure prevention tabs
(refer page 10), insert the cassette and tune to
the radio station (refer page 11) or select the aux
source (refer page 13).
1
Press [CLOCK/TIMER] to select your desired timer.
Each time you press the button:
CLOCK
˚ PLAY
Original display
˚ REC
2
Within 5 seconds, press [4/REW/4] or [3/FF/¢]
to set the starting time.
Play timer indicator
Start time
Record timer indicator
3
Press [CLOCK/TIMER] to confirm.
4
Repeat steps 2 to 3 to set the fi nishing time.
Finish time
To activate the timer
5
Press [˚PLAY/REC] to turn on your desired timer.
˚ PLAY
no display (off)˚ REC
6
Press [y] to turn off the unit.
The unit must be off for the timers to operate.
To enjoy the desired source after the timer setting is
completed.
The volume level (for play timer) and music source are stored
in the timer memory and the timer will start in these preset
conditions. However, the CD numbers do not get stored in
the timer memory.
1. After step 5, start playing the desired source.
2. Reset the CD numbers if you have changed any of them,
confi rm that a CD or cassette is inserted, then press [y] to
put the unit on standby.
Other basic operationsOther basic operations
To Action
change the settings Repeat steps 1 to 4 and 6 above.
change the source
or volume
1) Press [˚PLAY/REC] to clear the timer
indicator from the display.
2) Make changes to the source or
volume.
3) Do steps 5 to 6 as above.
check the settings
(when the unit is on
or in standby mode)
Press [CLOCK/TIMER] repeatedly to
select ˚PLAY or ˚REC.
cancel
Press [˚PLAY/REC] to clear the timer
indicators from the display.
Timer
PM31_7923-3P.indd 12PM31_7923-3P.indd 12 2/18/05 3:25:23 PM2/18/05 3:25:23 PM