Filter
Top Products
20
RQT7364
Listening operations
Cassette tapes
1 Press [OPEN 0] to insert a cassette.
Close the lid by hand.
2 Press [TAPE 3] to start playback.
Repeat step 1 and 2 to play the other side of the tape.
3 Adjust the volume.
Cassette tape selection and care
Types of cassettes which can be played correctly
Only normal position tapes are recommended.
NORMAL POSITION/TYPE I ✓
HIGH POSITION/TYPE II ✕
METAL POSITION/TYPE IV ✕
• Tapes exceeding 100 minutes are thin and can break or get
caught in the mechanism.
• Tape slack can get caught up in the mechanism and should
be wound up before the tape is played.
• Endless tapes can get caught up in the deck’s moving parts
if used incorrectly.
To find the beginning of a program
(TPS: Tape Program Sensor)
TPS finds the beginning of a track and resumes play from there.
Each press increases the number of tracks skipped, up to a
maximum of 9.
Press [
44
44
4/REW/4] or [
33
33
3/FF/¢] during play.
Note
The TPS function searches for silent parts of about 4 seconds
in length which are normally found between tunes. As a result,
it may not function properly in the following cases:
• With short silent parts
• When noise occurs between tunes
• With silent parts found within tunes
OPEN
3
2
1
Top of the unit
4
/REW/
4
,
3
/FF/
¢
STOP
7
,
–DEMO
1
OPEN 0
B
Insert inside the
guides
Forward side
B
2
TAPE
3
3
DOWN
VOLUME
UP
To
stop tape playback
start one touch play
fast-forward and
rewind
Action
Press [STOP 7, – DEMO].
Press [TAPE 3] when the system is
OFF with the cassette loaded.
Press [
44
44
4/REW/4] or [
33
33
3/FF/¢] in
the stop mode.
RQT7364-P_16-20_EN 30/12/03, 10:37 am20