Filter
Top Products
36
RQT8655
Sound effect
pDolby Digital and DTS are digital encoding systems used on DVD
to carry surround sound. Both were originally developed for use in
cinemas.
pThis unit automatically recognizes and decodes these systems.
Play a Dolby Digital or DTS source.
The Dolby Digital or DTS indicator lights.
w To down-mix Dolby Digital or DTS (multiple-
channel) signals to 2 channels
Press and hold [MIX 2CH].
pTo cancel, press and hold [MIX 2CH]
again.
pThis cannot be set while “Surround Music” or “Surround Enhancer”
(
➡
page 35) is set to “ON” (“ERROR” is displayed in the display
window). Please set this once “Surround Music” or “Surround
Enhancer” is set to “OFF”.
When “D.MIX” flashes on the display [DVD-A]
The DVD-Audio contains multiple-channel
signals that cannot be down-mixed.
Press [MUTING].
“MUTING” flashes on the unit's
display.
To cancel
pPress [MUTING] again or reduce the volume to minimum “VOL 0”,
then raise it to the required level.
pMuting is cancelled when you switch the unit to standby.
Press [SW.LEVEL].
Each time you press the button:
SUB WOOFER 1SUB WOOFER 2SUB WOOFER 3
SUB WOOFER 4 (factory preset)$
pThe setting you make is retained.
pThis cannot be set when headphones are connected.
Adjust the level of the speakers so they are the same apparent level
as the front speakers where you would normally be sitting and
listening.
Preparation
pPress [DRIVE SELECT] to select the DVD drive.
pTurn off the other sound effects.
pThis cannot be set while “Surround Music” (
➡
page 35) is set to
“ON” (“ERROR” is displayed in the display window). Please set this
once Surround Music is set to “OFF”.
You can adjust the balance of the front speakers.
pYou can also adjust the L/R Surround speakers while “Sound Field
Control (SFC)” or “Surround Enhancer” is set to on. Please
perform the following “When playing Multi-channel discs”
operations.
1 Press and hold [CH SELECT].
2 Press [, ] to adjust the “L”, “R”
balance.
1 Press and hold [CH SELECT].
2 While the screen above is being displayed
Press [CH SELECT] to select the speaker.
L, RCchRSchLSchSWch
$
SW: Subwoofer
pYou can only adjust SW if there is output from the subwoofer
channel.
3 Press [] (to increase) or [] (to
decrease).
L, R: Press [, ] to adjust the “L”, “R” balance.
C, RS, LS: L6 dB to K6 dB
SW: L6 dB to K6 dB
Dolby Digital and DTS
Software encoded with Dolby
Digital can be identified with
this mark.
Software encoded with DTS can
be identified with this mark.
SRD MUSIC
DRIVE SELECT
SW.LEVEL,
MIX 2CH
MUTING
CH SELECT
, , ,
ENTER
Muting the sound
Adjusting the subwoofer level
Speaker level adjustments
When stopped or playing discs with 2 channel or
monaural audio
When playing Multi-channel discs
RL
RL