Panasonic SC-HT680 Stereo System User Manual


 
23
RQT7969
This is one of the ways to get appropriate surround effects.
Preparation
Press [DVD/CD].
1 While stopped and no on-screen display is shown
Press [SHIFT]i[TEST] to output a test
signal.
L: Front left C: Center R: Front right
RS: Right surround LS: Left surround
There is no output from SW (subwoofer) channel.
2 Press [VOLUME, r] or [s] to set the
volume level normally used for listening.
3 Press [3] (increase) or [4] (decrease) to
adjust the speaker level for each speaker.
C, RS, LS: `6dB to i6dB
(L, R: Only the balance is adjustable.)
To adjust the balance of the front speakers
While outputting the test signal, press [2, 1].
Adjust the speaker level to the same level as the front
speakers.
To stop the test signal
Press [SHIFT]i[TEST] again.
To adjust speaker level during play
(Effective when playing multi-channel audio or when Dolby Pro
Logic II or Super Surround is on.)
1 Press [CH SELECT] to select the speaker.
L #C #R #RS #LS #SW
^-------------------------------------------------}
SW: Subwoofer
You can adjust SW only if the disc includes a subwoofer
channel.
“SW” does not appear on the display and is not adjustable
when Dolby Pro Logic II is turned on.
“S” appears on the display when “MUSIC” or “MOVIE” is
selected with Super Surround (page 22). In this case, you
can adjust both surround speaker levels at the same time
using [3, 4].
S:
`
6dB to
i
6dB
2 Press [3] (increase) or [4] (decrease) to adjust the
speaker level for each speaker.
C, RS, LS, SW: `6dB to i6dB
(L, R: Only the balance is adjustable.)
To adjust the balance of the front speakers
While “L” or “R” is selected, press [2, 1].
Speaker level adjustments
SHIFT
TEST
CH SELECT
Other useful functions
Press [SHIFT]i[SLEEP] to select the time (in
minutes).
SLEEP 30_----)SLEEP 60_----)SLEEP 90
^""""" OFF(_ SLEEP 120(__}
To cancel the timer
Press [SHIFT]i[SLEEP] to select “OFF”.
To confirm the remaining time
Press [SHIFT]i[SLEEP] again.
To change the setting
Repeat the procedure from the beginning.
Press [MUTING].
“MUTING” flashes on the unit’s display.
To cancel
Press [MUTING] again or reduce the volume to minimum (-- -- dB),
then raise it to the required level.
Muting is canceled when you switch the unit to standby.
1 Reduce the volume and connect the
headphones (not included).
Headphone plug type: 3.5 mm (
1
/8z) stereo
2 Adjust headphone volume with
[VOLUME].
Audio is automatically switched to stereo (2-channel).
[Note]
Avoid listening for prolonged periods of time to prevent hearing
damage.
Sleep timer
Muting
Using headphones
SHIFT
SLEEP
QUICK OSD
SLEEP
SETUP
MUTING
C
M
ain unit only
1
2345
OPEN
CLOSE
DISC CHANGE
DISC CHECK
SELECTOR
TUNE MODE
FM MODE MEMORY
PROGRESSIVECD MODE
DISC
POWER
DOWN UP
PHONES
VOLUME
AC IN
TUNING
VOLUME
Sound field and sound quality/Other useful functions