Filter
Top Products
7
RQT7429
Other speaker setup options
Other speaker setup options
[HT878] (Center speaker only) [HT870] [HT520]
∫ Attaching to a wall
1 Drive a screw (not included) into a wall.
2 Fit the speaker securely onto the screw(s) with the hole(s).
≥The wall or pillar on which the speakers are to be attached should be capable of
supporting 10 kg per screw. Consult a qualified building contractor when attaching the
speakers to a wall. Improper attachment may result in damage to the wall and
speakers.
[HT870]
≥When mounting the front and surround speaker to a wall, we recommend using a string (not included) to prevent it from falling (‹ page 5).
≥Use of optional speaker cables are recommended for wall-mounted front and surround speakers. (You can also remove the speaker cables
from the pipes supplied with this system.)
∫ Fitting speaker stands (not included)
[HT878] [HT870] (Center speaker only)[HT520]
Ensure the stands meet these conditions before purchasing them.
Observe the diameter and length of the screws and the distance between screws as shown in the diagram.
≥The stands must be able to support over 10 kg.
≥The stands must be stable even if the speakers are in a high position.
e.g. [HT520] Front speaker
Wall or pillar
230 mm
Front and surround speakers [HT870]
Center speaker [HT878]
86 mm
So that the speaker fits up against the wall squarely, be
sure to press the speaker cable down into the groove.
Center speaker [HT520]
Center speaker [HT870]
150 mm
270 mm
In this position, the
speaker will likely
fall if moved to the
left or right.
Move the speaker so
that the screw is in
this position.
Attach the stands to
these metal screw
holes.
Plate thickness
plus 7 to 10 mm
5 mm, pitch 0.8 mm
60 mm
Speaker stand
(not included)
7429en-p03-30.fm 7 ページ ２００４年３月５日 金曜日 午後８時１０分