Filter
Top Products
8
Outlaw Audio
Owner’s Manual
9
Model 200 M-Block Power Amplier
Owner’s Manual
Troubleshooting Guide
Problem Solutions
Amplier will not turn on
Master Power Switch turned off (No power light LED).
Turn on Master Power Switch.
Amplier will not turn on
Remote trigger cable not properly connected.
Verify connection of trigger cable at both ends.
Amplier turns on, but no audio is heard
Input plug not connected properly or is loose.
Check input connection.
No audio
Speaker not connected properly.
Check speaker connections at amp and speaker
Audio levels differ from other channels in the system
Improper settings or output levels from the processor or controller.
Check the settings on your preamp, processor or controller.
Audio plays, then cuts off
Amplier shorted.
Check speaker connections for short circuit at amp and speaker.
Care and Maintenance
Cleaning
When the unit becomes dirty, wipe it with a clean, soft, dry cloth. If necessary,
rst wipe the surface with a soft cloth slightly dampened with mild soapy water,
then with a fresh cloth dampened with clean water. Wipe dry immediately
with a dry cloth. NEVER use benzene, thinner, alcohol or any other volatile
cleaning agent. Do not use abrasive cleaners, as they may damage the nish
of the metal parts. Avoid spraying insecticide, waxes, polishing agents, or any
aerosol product near the unit.
Troubleshooting
Your Outlaw M-Block Amplier is designed for trouble free operation. If you
follow the instructions in this manual you should enjoy many years of high
quality listening enjoyment. However, as with any sophisticated electronic de-
vice, there may be occasional problems upon initial installation, or during the
life of the unit. The items on this list are a brief guide to the minor problems
that you may be able to correct yourself. If these solutions do not rectify a
problem, or if the problem persists, contact us for assistance.
Protection Circuitry
In the event that the amplier senses a shorted speaker wire, DC voltage on an
input connection, or thermal overload that could potentially cause damage to
the unit or to your speakers, it will automatically shut down.
If this should happen, rst check all speaker wire connections, both at the
speakers themselves and at the speaker terminals on the back of the Model 200
to make certain that none of the strands from the “positive” terminal touch
those from the “negative” terminal. Even a few stray wire strands can cause
the unit to go into the protection mode.
After checking all speaker connections, turn the unit back on. If it continues
to turn off, check your speakers to verify that they are operating properly. If all
other potential sources of trouble check out properly, contact Outlaw Audio for
further assistance and information.
Fuse Replacement
The fuse on the Model 200’s rear panel protects the unit’s power supply from
problems and is not part of the audio circuit. If you suspect that a malfunction
of the unit is caused by a blown fuse, be certain to replace it with an identical
type. Should the fuse continue to blow, discontinue use of the Model 200 and
disconnect it from both AC Power and all source components. Contact Outlaw
Audio for service information.
Outlaw Service Information
The Model 200 does not contain any user serviceable parts. If you suspect a
problem that may require service assistance, contact us via e-mail at custome
rservice@outlawaudio.com, or by phone at 866-OUTLAWS (688-5297).
It is important that an authorized service agent carry out any repairs. This
will ensure proper service and preserve the protection of your Limited War-
ranty. Keep your sales slip or receipt in a safe place with this manual so that it
will be available to verify the purchase date should you experience a problem
covered by our warranty.
Care and Maintenance