Filter
Top Products
- 5 -
Using the CD player
Handling Compact Discs
To remove a CD from its storage case, press
down on the centre of the case and lift the disc
out.
Hold the disc by the edges. Avoid touching
the recorded side of the disc.
Loading CDs
• Set the Function Selector to CD position.
• Press the “ OPEN” pad on the top of the
CD lid to click open.
• Place the CD in the compartment with the
label side facing upwards.
• Close the lid. When fully closed the CD
player starts to spin the disc. The display
shows the total number of tracks on the
CD.
• You can open the CD compartment at any
time by pressing the stop button lifting the
disc compartment lid.
• Only remove the CD when it has stopped
spinning.
Please note
• Do not put anything other than a CD in the
compartment. Other objects can damage
the mechanism.
• Do not force open the lid by hand during
use.
• Keep the lid closed when not in use to
prevent dirt and dust from getting into the
mechanism.
• Never insert more than one CD at a time.
• If a disc is deeply scratched or too dirty, it
may not play.
Error compensation
The unit has built in error compensation
circuits which enable it to keep playing
despite any minor defects in the disc.
However, if the defects are too great, the play
may skip some tracks during play.
If you encounter this problem play a new disc
and if the CD player operates normally, the
skipping problem is probably due to a
defective disc.
Playing CDs
• Once you have loaded a CD, press the CD
Play/Pause button. The display shows the
track currently playing.
• To stop play, press Stop.
Skip forward or back through tracks
• To select the next track, press >> Skip/
Search. If you are on the last track of the
disc, the player will move to track 1.
• To go back to the beginning of the current
track press << Skip/Search once.
• To go back to the previous track press <<
Skip/Search twice.
• To play a particular track, load the disc in
the CD player and press >> Skip/Search
until the track number you want is shown
in the display.
Pause
• To stop a track temporarily, press the Play/
Pause button. The disc will pause at the
current play position. The Play/Pause
indicator will flash.
• To resume play, press the Play/Pause
button again.