Filter
Top Products
brackets to the CD changer.
3. Using the supplied mounting studs as templates and the width between
the mounting brackets as a guide, mark the positions for the mounting
holes.
4. Attach the mounting studs to the mounting surface using the supplied
screws.
5. Attach the CD changer to the mounting studs using the supplied wing
nuts.
MOUNTING THE FM MODULATOR
1. Use the supplied screws to attach the FM modulator under the vehicle's
dashboard.
2. Use cable ties (not supplied) to secure the FM modulator's wires
under the dashboard.
MOUNTING THE COMMANDER
The supplied hook-and-loop fastener lets you securely mount the commander
on the dashboard and easily remove it when you need it.
Determine the commander's exact mounting location. Then follow these
steps to secure the commander.
1. Clean both mounting surfaces with isopropyl alcohol and allow them
to completely dry.
2. Peel the backing off one piece of the hook-and-loop fastener and press
it onto the back of the commander.
3. Peel the backing off the other piece of the hook-and-loop fastener
and press the commander onto the desired location.
RECONNECTING THE VEHICLE'S BATTERY
Reconnect the cable to the vehicle battery's negative (-) terminal.
SETTING THE FM FREQUENCY
Set 88.7 MHz/88.3 MHz on the side of the FM modulator to an active
frequency in your area, if available. This is the frequency you tune to on
your vehicle's sound system to hear the CD changer.