Wires and cables will not interfere with the vehicle's pedals or other
moving parts.
No component is directly in front of heating vents.
All wires and cables will reach their connection points.
2. Confirm that the CD changer and its components will fit the mounting
areas you select.
CAUTION: Be careful to avoid obstructions behind all mounting surfaces.
CD CHANGER
You can mount the supplied CD changer horizontally, at a 45-degree angle,
or vertically in your vehicle's trunk, on the floorboard, or under a seat.
CAUTION: Do not mount the CD changer upside down.
NOTES: The CD changer's mounting area must be at least 13 inches (33 cm)
deep.
When you choose a mounting area for the CD changer, make sure it is
close enough to the FM modulator's mounting area so you can connect
both components with the supplied CD changer cable. The cable is
about 16 feet (4.87 m) long.
Do not mount the CD changer anywhere in your vehicle that is
exposed to direct sunlight (such as the front or rear deck) or
extreme heat (such as the engine compartment). Direct sunlight
or extreme heat can damage CDs and the CD changer.
Make sure your vehicle's mounting area is as level as possible. If
you cannot mount the CD changer exactly level, make sure the CD
changer will not tilt more than 15 degrees from the horizontal,
45-degree, or vertical mounting positions.
Make sure there is enough room for you to insert and remove the
supplied CD magazine from the CD changer.
FM MODULATOR
You can mount the supplied FM modulator under your vehicle's dashboard.