Filter
Top Products
Operating Other Components with the Remote Controller
En-27
¼ Resetting the REMOTE MODE Buttons
You can reset the remote control code registered in the
REMOTE MODE button to its default status. This operation
can be executed on a single REMOTE MODE button.
1. Press and hold Q for 3 or more seconds while holding
down the REMOTE MODE button you want to reset.
● The remote indicator will light.
2. Within 30 seconds, press the REMOTE MODE button
again.
● Resetting is complete when the remote indicator
flashes twice.
To reset all the remote controller settings: While holding
down RECEIVER, press and hold Q for 3 or more seconds
until the remote indicator stays lit. Within 30 seconds, press
RECEIVER again. Resetting is complete when the remote
indicator flashes twice.
TV operation
Press the REMOTE MODE button programmed with
the remote control code for the relevant AV component
to switch the remote controller mode to that for the AV
component. Then, operate by using the corresponding
buttons. Available buttons vary depending on the product
category of the component. Operation may be incorrect or
impossible depending on the product.
1
2
4
3
1 REMOTE MODE
2 , INPUT, VOL /
3 MUTING
4 CH +/–
5
8
9
6
7
5 GUIDE
6 / / / , ENTER
7 HOME
8 PREV CH
9 RETURN
F
G
H
I
F , , , , , , ()
G A (Red), B (Green), C (Yellow), D (Blue)
H Number 1 to 9, 0, +10
I CLR, DISPLAY
¼½ Not CEC compatible.