Filter
Top Products
6
Step 1:
Connections
Installing speakers in ceiling
gh
ij
kl
g h
Top Front
i j
Top Middle
k l
Top Rear
Ceiling speakers, etc. are used for maximizing effects in
Dolby Atmos or Dolby Surround listening mode. Install
Top Front speakers midway between the position just
above the listening position and the position just above
the front speakers. Install Top Middle speakers just above
the listening position. Install Top Rear speakers midway
between the position just above the listening position and
the position just above the surround back speakers.
Combination patterns for Height speakers 1 and
2
Dolby recommends the following combination pattern
to obtain the best effect of Dolby Atmos and Dolby
Surround listening modes
r Pair 1 : Top Middle
r Pair 2 : Top Front / Top Rear
The following are the patterns of Height speakers 2 that
can be selected according to the type of Height speakers 1.
Height speakers1 : Front High
Height speakers 2: Not Use/Top Middle/Rear High/Dolby
Enabled Speaker (Surround)/Dolby Enabled Speaker
(Back)
Height speakers1 : Top Front
Height speakers 2: Not Use/Top Rear
Height speakers1 : Top Middle
Height speakers 2 cannot be used.
Height speakers1 : Dolby Enabled Speaker (Front)
Height speakers 2: Not Use/Dolby Enabled Speaker
(Surround)/Dolby Enabled Speaker (Back)
Height speakers1 : Dolby Enabled Speaker (Surround)
Height speakers 2 cannot be used.
Height speakers1 : Dolby Enabled Speaker (Back)
Height speakers 2 cannot be used.
r When front speakers are bi-amp connected, you can select
a pattern for Height speakers 2 from the following options.
Not Use/Front High/Top Front/Top Middle/Dolby Enabled
Speaker (Front)/Dolby Enabled Speaker (Surround)/
Dolby Enabled Speaker (Back)
Instructions on how to connect speakers
Important%QPPGEVURGCMGTUYKVJŝVQŝKORGFCPEG
You have to change the setting if any of the speakers have
ŝQTOQTGVQNGUUVJCPŝKORGFCPEG;QWECPUGVWRD[
viewing the guidance displayed on the TV screen. Press
RECEIVER and then HOME on the remote controller.
Select "Setup" - "2.Speaker Setup" - "Speaker Settings" -
"Speaker Impedance" and change the default value from
"6ohms" to "4ohms".
r Select the item with the cursor buttons of the remote
controller and press ENTER to confirm your selection. To
return to the previous screen, press RETURN.
If you use only one surround
back speaker, connect it to
the BACK L terminal.
F
Height 1 R
9
Height 1 L
3
Center
H
Height 2 R/
J
Wide R
G
Height 2 L/
I
Wide L
1
Front R
2
Front L
8
Surround back R
7
Surround back L
4
Surround L
5
Surround R