Onkyo TX-SR576 Stereo System User Manual


 
73
Advanced Setup
—Continued
This section explains items on the Miscellaneous menu.
Note:
This procedure can also be performed on the AV
receiver by using its [SETUP], [ENTER], and arrow
buttons.
Volume Setup
MaxVolume
With this setting, you can limit the maximum volume.
The Maximum Volume range is Off, 79 to 30.
PowOn Vol
This setting determines what the volume will be each
time the AV receiver is turned on.
The range is Last, Min, 1 to 79, Max.
To use the same volume level as when the AV receiver
was last turned off, select Last.
Note:
The Power On Volume setting cannot be set higher
than the Maximum Volume setting.
HP Level
With this setting, you can offset the headphone volume
relative to the main volume. This is useful if your head-
phones are too loud or too quiet at the volume setting you
usually use when listening through your speakers. The
headphone level can be set from –12 dB to +12 dB.
Miscellaneous Setup
(TX-SR576 only)
1
Press the [RECEIVER] REMOTE
MODE button, followed by the
[SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select
“6. Miscellaneous,” and then
press [ENTER].
3
Make sure that “6-1.Vol-
umeSetup” is shown on the dis-
play, and then press [ENTER].
4
Use the Up and Down [ ]/[ ]
buttons to select an item, and
use the Left and Right [ ]/[ ]
buttons to change it.
The items are explained below.
5
When you’ve finished, press the
[SETUP] button.
Setup closes.