Filter
Top Products
34
First Time Setup
—Continued
If the impedance of any of the connected speakers is 4
ohms or more but less than 6, set the minimum speaker
impedance to “4 ohms.”
Note:
Before you change this setting, turn down the volume.
Note:
• This procedure can also be performed on the AV
receiver by using the [SETUP], [ENTER], and arrow
buttons.
If you connect a video component to COMPONENT
VIDEO IN 1, 2, or 3, you must assign that input to an
input selector. For example, if you connect your DVD
player to COMPONENT VIDEO IN 2, you must assign
COMPONENT VIDEO IN 2 to the DVD input selector.
To upconvert and output composite video and S-Video
sources from the COMPONENT VIDEO OUT, select
the VIDEO setting.
Here are the default assignments.
Minimum Speaker Impedance Setup
(not North American model)
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “0. Hardware
Setup,” and then press [ENTER].
MUTING
PREVIOUS
MENU
GUIDE
TOP MENU
SP A
/
B
SETUPRETURN
PLAYLIST/CAT PLAYLIST/CAT
RANDOM
SUBTITLE
AUDIO REPEAT
--
/
---
TAPE
M
D/CDR
HDD
CABLE
ON/STANDBY
DIMMER
ENT
D TUN
SLEEP
10 11 12
INPUT SELECTOR
REMOTE MODE
V
1
V
2
V
3
C
DTAPE TUNER
DVD
MULTI CH
LISTENING MODE
TV
TEST
TONE
CH SEL
SURROUND
STEREO
LEVEL
+
LEVEL
-
VOL
VOL
SAT
VCR
TV
DVD
RECEIVER
C
D
INPUT
+
10
0
CLR
123
456
789
ENTER
CH
DISC
ALBUM
RETURN
1
1, 9
2–8
RECEIVER
SETUP
3
Use the Left and Right [ ]/[ ]
buttons to select the setting for
“Impedance.”
4 ohms:
Select if the impedance of any
connected speaker is 4 ohms
or more but less than 6.
6 ohms:
Select if the impedances of all
connected speakers are
between 6 and 16 ohms.
Press the [RETURN] button to go to
step 2 of the “Speaker Configuration”
(see page 35).
Component Video Setup
Input selector Default assignment
DVD IN1
VIDEO 1 VIDEO
VIDEO 2 VIDEO
VIDEO 3 VIDEO
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Compo-
nent,” and then press [ENTER].
RECEIVER
SETUP