Filter
Top Products
En-43
Advanced Setup—Continued
Note:
When the “Network Control” setting is set to “Disable”,
this setting cannot be selected.
6. Firmware Update
See “Firmware Update” for the update procedure.
Notes:
• The setup menu display will become available several
tens of seconds after the receiver has started up.
• Perform the firmware update only when such an
announcement is posted on the Onkyo web site. Visit
the Onkyo web site for the latest information.
• It takes about 5 minutes to complete the firmware
update.
Version
Displays the current version of the firmware.
Receiver
via NET:
Performs the firmware update via Internet. Check the
network connection before updating.
via USB:
Performs the firmware update from a USB device.
These settings allow you to update the receiver’s
firmware. Do not shutdown the power of the receiver
while updating.
Universal Port
via NET:
Performs the firmware update via Internet. Check the
network connection before updating.
via USB:
Performs the firmware update from a USB device.
You can update the Onkyo dock’s firmware. Do not
shutdown the power of the receiver while update.
Note:
This update must not be performed if no dock is
connected to the UNIVERSAL PORT jack.
If you’ve made a change to any item, the display will
indicate “SAVE [ENTER]: [SELECT]” when you
exit Network Setup. If you want to apply the changes
you made, press [ENTER]. If you want to re-do the
setup, press [RETURN] to re-do the procedure from
the beginning.