Onkyo SR308 Stereo System User Manual


 
12
En
Connecting the Speaker Cables
Screw-type speaker terminals
Using Banana Plugs (North American models)
If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
Do not insert the speaker code directly into the center hole of the speaker terminal.
Push-type speaker terminals
The following illustration shows which speaker should be connected to each pair of terminals.
Connecting a Powered Subwoofer
Using a suitable cable, connect the AV receiver’s SUB-
WOOFER PRE OUT jack to an input on your pow-
ered subwoofer, as shown. If your subwoofer is
unpowered and you’re using an external amplifier, con-
nect the SUBWOOFER PRE OUT jack to an input on
the amp.
Strip 1/2" to 5/8" (12 to 15 mm) of insu-
lation from the ends of the speaker
cables, and twist the bare wires tightly,
as shown.
1/2" to 5/8"(12 to 15 mm)
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as shown.
3/8" to 1/2"(10 to 12 mm)
Surround right
speaker
Surround left
speaker
Front right
speaker A
Front left
speaker A
Front left
speaker B
Front right
speaker B
Center
speaker
Speakers BSpeakers A
IE NUT
LINE INPUT
Powered subwoofer