42
Using the timer
3
Press the
or
button to set the
ON time, and press the ENTER button.
Notes
• You can also use the number buttons
instead of the or button to set
the desired recording ON and OFF time. To
do so, refer to step 3 on page 24 and select
the 24-hour display. You cannot use the
number buttons if you select the 12-hour
display.
• When you use the timer to record to the
MD recorder, the data may not be
recorded for a few seconds at the start of
the recording. In this case, set the record-
ing start time about a minute early.
• When you store the ON time, the display
automatically indicates that the OFF time is
one hour after the ON time you specified.
4 P
ress the
or
button to set the
OFF time, then press the ENTER button.
5 Press the or button to select
the source (FM, AM, LINE/DVD), and
press the ENTER button.
If you select “FM” or ”AM“, press the
or
buttons again to select the preset num-
ber, then press the ENTER button.
6 Press the or button to select
the recording component (TAPE REC,
MD REC, or MD/TAPE), and press the
ENTER button.
Notes
• After you set the timer while the unit is in
Stand-by Off mode, pressing the ENTER
button turns off the display indicator.
• When you record analog FM or AM sig-
nals to an MD recorder, be sure to use
Analog In on the MD recorder.
(continued on the next page)
REPEAT
STANDBY/ ON
TAPE
TAPE REW TAPE FF
SLEEP TIMER ENTER
CLOCK
MODE
CLEAR
SCROLL
CDR/PC
CD/ DVD
MD FM AM
ACOUSTIC
PRESENCE
INPUT SELECTOR
TAPE
CDR/PC
CD/DVD
MD
V
O
L
U
M
E
MUTING
7
8
9
10/0
4
5
6
2
3
1
--
/
---
UP
DOWN
TIMER
ENTER
,
ENTER
ENTER
ENTER
ENTER