Filter
Top Products
13
En
Connecting the Speaker Cables
Screw-type speaker terminals
Using Banana Plugs (North American models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
Push-type speaker terminals
The following illustration shows which speaker should be connected to each pair of terminals.
Strip 1/2" to 5/8" (12 to 15 mm) of insu-
lation from the ends of the speaker
cables, and twist the bare wires tightly,
as shown.
(Supplied speaker cables are already
stripped.)
Strip 3/8" to 1/2" (10 to 12 mm) of insulation from the ends of the
speaker cables, and twist the bare wires tightly, as shown.
(Supplied speaker cables are already stripped.)
1/2" to 5/8" (12 to 15 mm)
3/8" to 1/2" (10 to 12 mm)
Surround
right
speaker
Surround
left
speaker
Front right
speaker A
Front left
speaker A
Center speaker
Subwoofer
Blue
Red
Gray
Purple
White
Green
Front right
speaker B
Front left
speaker B
Speakers BSpeakers A