Filter
Top Products
Advanced Operations
En-55
IntelliVolume
■ IntelliVolume
`–12dB to 0dB
to +12dB in 1 dB steps.
With IntelliVolume, you can set the input level for each
input selector individually. This is useful if one of your
source components is louder or quieter than the others.
Use / to set the level.
If a component is noticeably louder than the others, use
to reduce its input level. If it’s noticeably quieter, use to
increase its input level.
Note
• IntelliVolume does not work for Zone 2.
A/V Sync
■ A/V Sync
`0msec
to 800 msec in 10 msec steps
When using progressive scanning on your Blu-ray
Disc/DVD player, you may find that the picture and sound
are out of sync. With this setting, you can correct this by
delaying the audio signals.
To view the TV picture while setting the delay, press
ENTER.
To return to the previous screen, press RETURN.
The range of values you can adjust will depend on whether
your TV or display supports HDMI Lip Sync and if the
“LipSync” setting is set to “On” or not (➔ page 61).
Note
• A/V Sync is disabled when the Direct listening mode is used with
an analog input source.
• This setting cannot be used with the NET input selector.
Name Edit
You can enter a custom name for each individual input
selector and radio preset for easy identification. When
entered, the custom name will appear on the display.
The custom name is edited using the keyboard screen.
■ Name
Tip
• To name a radio preset, select AM or FM, and then select the
preset (➔ page 31).
• To restore a name to its default, erase all characters with CLR,
select “OK” and then press ENTER.
Note
• This setting cannot be used for the NET and USB input selectors.
1
Use / / / to select a character, and then
press ENTER.
Repeat this step to enter up to 10 characters.
2
To store a name when you’re done, be sure to
select “OK” by using / / / , and then press
ENTER.
BD/DVD
Shift All Erase
Shift All Erase
4 - 4. Name Edit
Name
+10 CLR
+10 CLR
a b c d e f g h i j k l m
n o p q r s t u v w x y z
1 2 3 4 5 6 7 8 9 0 – ^ \
Space
Back Space
Shift OK
, . / ; : @ [ ]
Space
Back Space
Shift OK
A B C D E F G H I J K L M
N O P Q R S T U V W X Y Z
+ ?
` { } < >
! ˝ # $ % & ’
) ( _ = | ˜
Name input area
Space:
Enters a space character.
Shift
*1
:
Toggles between lower and upper case characters.
(Left)/ (Right):
Moves the cursor left or right in the Name input
area.
Back Space
*2
:
Moves the cursor backward and deletes one
character.
OK:
Confirms your entry.
Tip
*1
This can also be performed by using +10 on the remote
controller.
*2
Press CLR on the remote controller to delete all the
characters you have input.