Turning On & Basic Operations
En-20
Initial Setup
This section explains the settings that we recommend you
to make before using the AV receiver for the very first
time. A setup wizard is launched upon first-time use to let
you perform those settings.
This step determines the language used for the onscreen
setup menus. See “Language” in “OSD Setup”
(➔ page 59).
Tip
• Pressing HOME will close the setup wizard. To restart the initial
setup, select “Initial Setup” in the “Hardware Setup” menu
(➔ page 62).
After selecting the language for on-screen setup menus, a
welcome screen is displayed.
This step performs the automatic speaker setup.
The on-screen menus appear only on a TV that is
connected to HDMI OUT MAIN.
Selecting the Language for the
Onscreen Setup Menus
1
Use / on the AV receiver or remote controller to
select one of the following options, and then press
ENTER.
`Yes:
Continues to “Audyssey 2EQ: Auto Setup”.
`No:
Skips the settings and terminates the initial
setup. The setup wizard goes to “Terminating the
Initial Setup”. You can always restart the initial
setup by selecting “Initial Setup” in the
“Hardware Setup” menu (➔ page 62).
1st Step : Audyssey 2EQ: Auto Setup
2nd Step : Source Connection
3rd Step : Remote Mode Setup
4th Step : Network Connection
Yes
No
Exit
Initial Setup
HOME
Welcome to initial setup. Have you connected all the speakers and devices?
Before starting, please connect speakers and sources.
Now, would you like to start initial setup?
Audyssey 2EQ: Auto Setup
1
Use / to select one of the following options, and
then press ENTER.
`Do it Now:
The automatic speaker setup is performed
following instructions on screen. Refer to step 2
of “Using the Automatic Speaker Setup”
(➔ page 32). When this setting is complete, the
setup wizard continues to “Source Connection”.
`Do it Later:
Skips this setting.
Press ENTER and continue to “Source
Connection”.