Filter
Top Products
35
First Time Setup
—Continued
Notes:
• When the automatic speaker setup is complete, the
Equalizer Settings (page 63) will be set to “Audyssey.”
• When the automatic speaker setup is complete, the
Audyssey Dynamic EQ settings (page 57) will be set
to “On.”
Error Messages
While the automatic speaker setup is in progress, one of
the following error messages may appear:
Ambient noise is too high
This message appears if there’s too much background
noise and the measurements cannot be performed prop-
erly. Remove the source of the noise and try again.
Speaker Detect Errors
This message appears if one of the speaker-related errors
below occurs.
• One of the front speakers has not been detected.
• One of the surround speakers has not been detected.
• The number of speakers detected on the second or
third measurement was different to the number
detected on the first measurement.
Write Error
This message appears if saving fails.
❑
Mismatch Error
This message appears if a speaker that was detected
during the 1st measurement is not detected during the
2nd or 3rd measurements. If this message appears, check
your speaker connections, and then try again.
3
Press [ENTER].
The automatic speaker setup starts.
You can cancel the automatic speaker setup at
any point in this procedure simply by discon-
necting the setup microphone.
A test tone is output by each speaker in turn, as
the Audyssey 2EQ function determines which
speakers are connected. This takes a few min-
utes.
Note:
• Quiet the room as much as possible. Back-
ground noise can disrupt the room measure-
ments. Close windows, silence cell phones,
televisions, radios, air conditioners, fluores-
cent lights, home appliances, light dimmers,
or other devices, and refrain from talking.
4
When the following display appears,
move the speaker setup microphone to
measurement point
2
(page 34), and
then press [ENTER].
Audyssey 2EQ performs more measurements.
This takes a few minutes.
5
When the following display appears,
move the speaker setup microphone to
measurement point
3
(page 34), and
then press [ENTER].
Audyssey 2EQ performs more measurements.
This takes a few minutes.
When the measurements are complete, the
results are calculated and saved automatically.
6
When the automatic speaker setup is
complete, disconnect the speaker setup
microphone.
HT-R518_En.book Page 35 Tuesday, March 11, 2008 11:31 AM