Filter
Top Products
9
Getting to know Your Speaker Package
—Continued
A
STANDBY/ON indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
With the Auto Standby function, the SKW-750X
automatically turns on when an input signal is
detected in Standby mode. When there’s no input
signal for a while, the SKW-750X automatically
enters Standby mode.
B
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
C
LINE INPUT
This RCA input should be connected to the sub-
woofer pre out on your AV receiver with supplied
RCA cable.
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
the AV receiver.
To set the level of the subwoofer, use the OUTPUT
LEVEL control. Set it so that bass sounds are evenly bal-
anced with the treble sounds from the other speakers.
Because our ears are less sensitive to very low bass
sounds, there’s a temptation to set the level of the sub-
woofer too high. As a rule of thumb, set the subwoofer
level to what you think is the optimal level, and then back
it off slightly.
Subwoofer (SKW-750X)
23
SKW-750X
1
■ Rear
To AC outlet
■ Front
Setting the Subwoofer Level
If the subwoofer is placed on a hard floor (wood,
vinyl, tile, etc.) and playback is very loud, the sub-
woofer's feet may damage the flooring. To prevent
this, place the supplied pads
underneath the subwoofer's feet.
The pads also provide a stable
base for the subwoofer.
OUTPUT LEVEL
MAX
MIN