4
Speaker Precautions
—Continued
Speaker care
Wipe the cabinet occasionally with a dry silica or soft
cloth. For heavier dirt, after dampening a soft cloth in a
weak solution of mild detergent and water and wringing
it out dry, wipe off the dirt. Then, dry immediately with
a clean cloth. Do not use rough material, thinners, alco-
hol or other chemical solvents or cloths since these could
damage the finish, remove the panel lettering, or cause
discoloration. If you are using a chemical cloth, always
follow the instructions that come with the cloth. For dust
accumulated on grilles, use a vacuum cleaner or brush it
off.
Power Cord Precautions
• Before connecting the power cord, connect all of your
speakers and AV components.
•Turning on the SKW-750X may cause a momentary
power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the SKW-750X into a different branch circuit.
1.
Be sure to tighten the screws when you assemble the
speaker stands and attach the brackets to the speak-
ers.
2.
The speaker stands are tall. Install the stands in a
manner that will not allow the speakers to tip over.
You may want to use commercially available chains
to prevent the stands from falling in the event of an
earthquake.
3.
Do not place the stands on an unstable table, slope,
or thick carpet. Otherwise, the stands may fall, caus-
ing injury.
4.
Place the stands in a location in which they would
not cause injury if they accidentally fell.
5.
Do not place the stands in an area at risk of fire or
damage, such as near a fireplace, heater, glass win-
dow, etc.
Speaker Stand AS-140 Precautions