Onkyo R-805X Stereo Amplifier User Manual


 
21
Preparing the remote controller
1 Remove the battery compartment
cover by pressing and sliding it away
from the remote controller unit.
2 Insert two AA-size batteries into the
battery compartment.
Carefully follow the polarity diagram
(positive + and negative - symbols)
inside the battery compartment.
3 After batteries are installed and
seated correctly, replace the compart-
ment cover.
Notes
Do not mix new batteries with old batter-
ies or different kinds of batteries.
To avoid corrosion, remove the batteries
if the remote controller is not to be used
for a long time.
Remove dead batteries immediately to
avoid damage from corrosion. If the
remote controller doesn’t operate
smoothly, replace both the batteries at
the same time.
The life of the batteries supplied is about
six months but this will vary depending
on usage.
Point the remote controller toward the
remote control sensor.
Notes
Place the unit away from strong light such
as direct sunlight or inverted fluorescent
light which can prevent proper operation
of the remote controller.
Using another remote controller of the
same type in the same room or using the
unit near equipment which uses infrared
rays may cause operational interference.
Do not put any object such as a book on
the remote controller. The buttons of the
remote controller may be pressed by mis-
take and drain the batteries.
Make sure the audio rack doors do not
have colored glass. Placing the unit
behind such doors may prevent proper
remote controller operation.
If there is any obstacle between the
remote controller and the remote control
sensor, the remote controller will not
operate.
Installing the remote controller
batteries
Using the remote controller
STANDBY/ON
DISPLAY
PHONES
MEMORY
CLEAR
FM MODE
PRESET
TUNING
R-805X
FM STEREO / AM TUNER AMPLIFIER
ENERGY SAVE
ACOUSTIC
PRESENCE
OFF/1/2/3
CD MD CDR LINE/DVD
FM AM TAPE
INPUT
VOLUME
R-805X
30˚
30˚
Remote control
Control range
About 5 m
(16 feet)
sensor