Filter
Top Products
9
Operation
1. Turn on the power of the sur-
round receiver.
Perform the necessary settings, such as
adjusting output level of each channel,
on the surround receiver.
See the instruction manual of your
surround receiver for details.
2. Set the surround receiver’s Input
Selector as follows:
TX-SV919THX: “VIDEO-4”
TX-SV828THX: “VIDEO-1”
Then, select the External Decoder mode
on the surround receiver.
(See also "For connection to the Onkyo
TX-SV919THX/TX-SV828THX
surround receiver..." on page 8.)
3. Press the POWER button on the
ED-901 to turn it on.
4. Press the INPUT 1 (VDP) or
INPUT 2 (DVD) input selector
button.
The LED for the selected input source
will light.
5. Play the AC-3 sound source.
The PROGRAM STATUS indicator
will appear on the display.
Note:
• Before performing the following procedure, make sure that the
ED-901 is properly connected to the surround receiver.
• To play Dolby Pro Logic sound sources...
The ED-901 is not equipped with a Dolby Pro Logic decoder.
To play Dolby Pro Logic sound sources, connect the ED-901 to
your receiver by audio cables and set the receiver's Input
Selector to Analog Input ("VIDEO-4" for the TX-SV919THX
and "VIDEO-1" for the TX-SV828THX).
3
4
3
4
POWER
ON OFF
INPUT 1 (VDP)
INPUT 2 (DVD)