Filter
Top Products
31
En
Custom Setup
Custom Setup
To cancel the procedure at any point, press SETUP.
Setup Procedures
1
Press SETUP.
2
Use / or / to select the preference you
want to change.
The preferences are explained in the next column.
3
Press ENTER or .
4
Use / or / to select the preference’s
options.
5
Press ENTER or .
When the preference has been set, “FINISH” appears
on the display.
, ,
SETUP
,
ENTER
■ FILTER
`SHARP (default)
This preference allows the band property up to
20 kHz to be output almost flat.
`SLOW
This preference brings higher reproducibility of
input waveform, and is suitable to reproduce
agogics, or subtle attack of sound signals, along with
sound image localization for each musical
instrument.
This preference configures the setting to switch the
characteristics of the digital filter for D/A conversion.
You can opt for whichever of the characteristics that
vary depending on your switching.
■ PHASE
`NORMAL (default)
The waveform recorded in disc will be output with
its polarity left intact.
`REVERSE
The waveform recorded in disc will be output with
its reversed polarity.
This preference configures the setting to switch the
phase of the analog audio output.
You may give it a try to switch and listen so that an
optimum sound quality can be obtained from the
amplifier and the speakers on line.
■ DISC
`DISPLAY (default)
`NOT
This preference determines whether or not the disc
name is displayed when an MP3/WMA CD is read.
■ FILE
`SCROLL (default)
`NOT
This preference determines whether or not the file name
scrolls across the display when an MP3/WMA file is
selected.
In Navigation mode, the file name scrolls across the
display regardless of this setting (➔ 23).
■ FOLDER
`SCROLL (default)
`NOT
This preference determines whether or not the folder
name scrolls across the display when an MP3/WMA
folder is selected.
In Navigation mode, the folder name scrolls across the
display regardless of this setting (➔ 23).
■ HIDE-NUM
`DISABLE (default)
Displays numbers.
`ENABLE
Hides numbers.
This preference determines whether or not the numbers
at the beginning of file and folder names are hidden.
When you create an MP3/WMA CD on a personal
computer, you cannot normally determine the playback
order of the files. However, if you number the
MP3/WMA files in order, starting with 01, 02, 03, and
so on, they will play in that order.
■ BAD-NAME
`NOT (default)
`REPLACE
This preference determines whether or not file and
folder names that contain undisplayable characters are
replaced with “FILE n.” or “FOLDER n.”, “n” being the
file or folder number. When set to “NOT”, displayable
characters are displayed and underscores are used in
place of any undisplayable characters. For ID3 tags,
underscores are used in place of undisplayable
characters regardless of this preference.
Preferences
AUDIO
DISPLAY