Filter
Top Products
9
Remote Controller—Continued
Detach the battery
cover.
Insert the two R6 (size
AA) batteries.
Be sure to match the +
and – ends of the batter-
ies to the diagram inside
the battery compart-
ment.
Attach the battery
cover.
Notes:
• Do not mix new batteries with old batteries. Do not
mix different kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long period of time.
• Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller does not
operate smoothly, replace both batteries at the same
time.
• The life of the batteries supplied is about six months
but will vary depending on usage.
Point the remote controller toward the remote control
sensor.
Notes:
• Place the unit away from strong light such as direct
sunlight or inverted fluorescent light, which can pre-
vent proper operation of the remote controller.
• Using another remote controller of the same type in
the same room or using the unit near equipment that
uses infrared rays may cause operational interference.
• Do not put any object, such as a book, on the remote
controller. The buttons of the remote controller may
accidentally be pressed and drain the batteries.
• Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
• If there is an obstacle between the remote controller
and the remote control sensor, the remote controller
will not operate.
Inserting the Batteries Using the Remote Controller
D
I
G
I
T
A
L
O
U
T
P
U
T
D
I
S
P
L
A
Y
C
-
1
VL
C
O
M
P
A
C
T
D
I
S
C
P
L
A
Y
E
R
P
O
W
E
R
Remote control sensor
A
bout 5 m
(16 feet)