Filter
Top Products
En-14
Other Settings (Reset Procedure)
When the ABX-100 is in Standby mode, pressing the
remote’s [MENU] button will display the following items.
The available settings for each item are shown below.
(The default setting is underlined.)
“12/24H Format” 12H 24H
Switches the time format between
12-hour and 24-hour. On models for
the North American market, the
default setting is “12H”; for other
models, the default setting is “24H.”
“Beep” On Off
Switches on/off the beep tone that
sounds when you press a button on
the top panel of the ABX-100.
“Volume Limit” 10 40
Specifies the maximum volume in
the range of 10–40. The default
setting is 40.
“Reset” Cancel OK
If you select OK and then press the
[ENTER] button, the ABX-100 will be
reset to its factory-set state.
1
Use the []/[] buttons to select a menu
item, and then press the [ENTER] button.
2
Use the []/[] buttons to change the
setting.
3
Press the [ENTER] button to finalize the
change, and exit the menu.
Note:
• During this procedure, you can press the [MENU]
button to exit the settings.
Troubleshooting
If you experience any problem while using the
ABX-100, look for a solution in this section.
Can’t turn on the ABX-100.
• Make sure that the AC adapter is properly plugged
into the wall outlet, and that the DC IN connection has
been made correctly (see page 7).
• Unplug the AC adapter from the wall outlet, wait 10
seconds or more, then plug it in again.
The ABX-100 turns off unexpectedly.
• If the sleep timer has been set and the SLEEP indicator
is shown on the display, the ABX-100 will turn off
automatically after a specified period (see page 13).
• When timed playback finishes, the ABX-100
automatically switches to Standby mode (see
page 12).
There’s no sound.
• Make sure the ABX-100’s volume is not set too low
(see page 7).
• Make sure the correct input source is selected (see
page 7).
• Make sure the ABX-100 is not muted (see page 8).
• Check all connections and correct as necessary (see
page 7).
The sound quality is not good.
• The sound quality can be affected by strong magnetic
fields, such as that from a TV. Try moving any such
devices away from the ABX-100.
• If you have any devices that emit high-intensity radio
waves near the ABX-100, such as a cellular phone
that’s being used to make a call, the ABX-100 may
output noise.
Audio output is intermittent when the
ABX-100 is subjected to vibration.
The ABX-100 is not a portable device. Use it in a
location that’s not subject to shock or vibration.
12/24H Format
Beep
Volume Limit
Reset
Power
If you can’t resolve the issue yourself, try resetting
the ABX-100 before contacting your Onkyo dealer.
Reset the ABX-100 as described in the “Reset”
section of “Other Settings” (this page).
Note that resetting the ABX-100 will delete your
custom settings.
Audio