Filter
Top Products
41
En
If you want to control an Onkyo component by pointing the
remote controller directly at it, use the following remote
control codes:
`32900:
Onkyo Blu-ray Disc player
`32901:
Onkyo HD-DVD player
`70868:
Onkyo MD recorder
`71323:
Onkyo CD recorder
`82990:
Onkyo Dock
Note
• If you connect a cassette tape deck to the TV/CD IN jack, or
connect an RI Dock to the TV/CD IN or VCR/DVR IN or
GAME IN jacks, for to work properly, you must set the Input
Display accordingly (➔ 20).
You can reset a REMOTE MODE to its default remote
control code.
You can reset the remote controller to its default settings.
By pressing REMOTE MODE that’s been programmed
with the remote control code for your component, you can
control Onkyo component as below.
For details on entering a remote control code for a differ-
ent component (➔ 40).
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the .
The component must be able to receive remote control
commands via and be connected to the AV
receiver via HDMI.
Resetting REMOTE MODE Buttons
1
While holding down REMOTE MODE that you
want to reset, press and hold down AUDIO until
the remote indicator lights (about 3 seconds).
2
Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that
the button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its pre-
programmed code is restored.
Resetting the Remote Controller
1
While holding down RECEIVER, press and hold
down AUDIO until the remote indicator lights
(about 3 seconds).
2
Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that
the remote controller has been reset.
Controlling Other Components