Filter
Top Products
16
2.2 Regional Setup (Fig. 27): Depending on your geographic
location, the tuner needs to be set for the proper tuning
standard. The choices are USA & Canada, Western Europe,
Australia, and New Zealand. Countries outside these
geographic locations need the advanced custom setting (see
Section IV. Advanced Settings: 4.1 Custom Regional Setup,
pg.18).
Fig. 27
2.3 Brightness (Fig. 28): This sets the intensity of the display
for the tuner. The factory default is the maximum level, 8.
Fig. 28
Fig. 29
2.4 Auto-On (Fig. 29): In the event of loss of power, or if the
Tuner is unplugged, the tuners can be set with this check box
to automatically turn on when power is restored. Note that this
feature is only necessary for non-NuVoNet use, since NuVoNet
causes the tuners to turn on when a zone within the NuVo
System is turned on. The tuners will turn off when all NuVo
System zones are turned off.
2.5 Disable Bands (Fig. 30): These check boxes allow you to
disable the AM or FM bands. This is useful for areas where
reliable reception is not possible.
Reset Config: This button will reset all of the configuration
information to the original factory default settings.
Fig. 30