Filter
Top Products
Antenna Input
The T2 ships with a proprietary amplified AM/FM antenna. This
antenna is designed to work only with the NuVo T2 series
tuners. It can be located up to 200 feet from the tuner location,
and we recommend 75-ohm RG 6 coaxial cable with a standard
F style connector on each end. Simply attach the cable to the
connector at the bottom of the antenna, and into the “Antenna
Input” on the T2, fig. 7. Once connected, the T2 should
immediately receive broadcast signals and RDS (Radio Data
Service) when it is available.
We recommend placing the antenna inside in an attic or as
high as possible for the best possible AM and FM reception,
fig. 8. A 2 meter (6 foot) pre-terminated coaxial cable is
provided with the tuner package for testing the antenna
connection or if you choose to place the antenna close to the
tuner location.
L
L
OUTAUX IN
R
R
TRIGGER
ON=+12V
AUDIO
OUTPUT
TUNER B TUNER A
OUT
AUDIO
OUTPUT
ANTENNA INPUT
IN
USE ONLY NuVo
NV-T2PAS
POWERED ANTENNA SYSTEM
TRIGGER
ON=+12V
AUX IN
Fig . 7
Fig . 8
USB and RS232 Communication
The T2 has two serial communication ports. These allow for
complete control of the T2 functions by RS232 control devices.
The necessary protocol for RS232 control is available through
the NuVo Website Prozone at
. www.nuvotechnologies.com/prozone
Page 10