Filter
Top Products
PAGE 3 CONTROLS
CONTROLS
General Controls
1. Power Button
Pushing this button down turns on the turntable.
2. Start/Stop Buttons
These buttons start and stop the turntable motor. Both buttons have the same function.
3. Platter
This turntable has a special edge design that has been optimized for "dragged" platter slow downs.
4. Pitch Slider
This slide control allows the pitch to be increased or decreased by 10%. In the center position the pitch is
at 0%. When moved away from the center and towards the tone arm decreases the pitch (slows down the
platter) and moving the pitch slider away from the tone arm increase the pitch (speeds up the platter)
5. Pitch LED
This LED illuminates green when the pitch is set at 0%. When the pitch slider is moved away from zero,
the LED illuminates red.
6. 33 and 45 RPM Buttons
These buttons control the RPM of the turntable platter. A red LED indicates which RPM mode has been
selected.
NOTE: If the turntable is powered down while in the 45 RPM setting, it will return to 33 RPM when it is
powered up.
1
4
56
3
2