Filter
Top Products
Installation Considerations
SVL-4AB Power Handling
The SVL-4AB is designed for use with receivers or amplifiers
having a maximum power output of 100 watts per channel at
8 ohms. Damage caused by the use of higher-power receivers
or amplifiers will void the warranty. Consult your Niles dealer
or receiver/amplifier manufacturer if you are uncertain about
the power rating of your receivers or amplifiers.
IMPORTANT: DO NOT USE THE SVL-4AB WITH AMPS OR
RECEIVERS RATED AT MORE THAN 100 WATTS PER CHANNEL
RMS AT 8 OHMS.
Amplifier Impedance Load
As more pairs of speakers are parallel connected to a receiver
or amplifier, the overall system impedance becomes lower.
For example, if two pairs of 8-ohm speakers are connected in
parallel, the impedance will be 4 ohms; two pairs of 4-ohm
speakers in parallel become 2 ohms, and so on.
Most receivers or amplifiers are not rated for use below a
4 ohm load. Most manufacturers do not
recommend
connecting more than two pairs of speakers without using
some form of impedance correction.
4
S
PEAKER
S
ELECTION
/V
OLUME
C
ONTROL
S
YSTEM
IMPORTANT
DO NOT use the
SVL-4AB with amps
or receivers rated
at more than 100
watts per channel
RMS at 8 ohms.
TOOLS
REQUIRED
• 1/8" Standard
Slotted Screwdriver
• Wire Stripper