Filter
Top Products
S
PEAKER
S
ELECTION
/V
OLUME
C
ONTROL
S
YSTEM
14
9. You can turn off the speakers by turning the correspond-
ing volume controls on the SVL-4AB fully counter-clockwise,
or by pressing the appropriate ON/OFF button. Refer to the
Protection Chart located on page 13 for the correct setting of
the PROTECTION button.
10. At any time, you may choose to switch any of the active
speaker pairs to one or the other of the amplifiers by pressing
the corresponding amplifier A/B button.
Constant Protection Switches
The SVL-4AB is equipped with rear panel overrides of the
protection circuits that enables you to maintain constant
impedance protection regardless of the position of the front
panel switch. This will safeguard either or both of your ampli-
fiers from being overdriven due to accidental or improper
use by anyone unfamiliar with the equipment.
To engage one or both of these overrides, move the rear
panel "CONSTANT PROTECTION" switches to the "ON" posi-
tion. Constant impedance protection will be maintained until
the switches are turned to "OFF".
SPECIFICATIONS
Audio Power
Handling
100 watts/channel
continuous music
power
Frequency Response
+/- 1.2 dB from 20 Hz
to 20 kHz
Mounting
Table-Top component
Wiring Requirements
Individual runs of
2-conductor speaker
wire. Connectors
accommodate wire
sizes 14-22 gauge (16
gauge recommended)
Overall Dimensions
17" (432mm) wide x
2" (51mm) high x
9 1/4" (235mm) deep
Weight
7 1/2 lbs. (3.4 kg).