Filter
Top Products
Operation
The are two ways to use the SVL-4AB. You may play and
adjust the volume of one pair of speakers at a time, or play
multiple pairs simultaneously.
If you intend to play more than one pair of speakers at the
same time, you will need to become familiar with the opera-
tion of the SVL-4AB's PROTECTION button.
Playing One Pair of Speakers At a Time
1. Make sure the amplifier or receiver power is OFF and set
the volume to minimum.
2. Set the SVL-4AB volume control for the speaker pair you
wish to play to maximum (fully clockwise).
3. Locate the ON/OFF button on the SVL-4AB which corre-
sponds to the speaker pair you wish to play. Set it to the ON
position.
4. Adjacent to the ON/OFF button is the amplifier A/B but-
ton. Choose an amplifier for the active speaker pair by press-
ing the A/B button in for “B” and out for “A”.
5. Turn on the amplifier or receiver and select a source, such
as the tuner or CD player.
6. Slowly turn up the amplifier or receiver volume and set it
to a comfortable (not maximum) listening level. Be careful
11
S
PEAKER
S
ELECTION
/V
OLUME
C
ONTROL
S
YSTEM
"TECH TIP"
If your amplifier or
receiver has "A"
and "B" speaker-
pair outputs,
connect the SVL-4AB
to the "A" outputs.
Do not connect
anything to "B".
This will prevent
the amplifier or
receiver from driving
an unusually low
impedance load.