Filter
Top Products
Introduction
The SS-4/SS-6 allows you to connect multiple pairs of speakers
to your stereo receiver or amplifier and play any pair, any
combination of pairs, or all pairs simultaneously. You don’t
have to worry about overloading your amplifier. The SS-4/SS-6
has a protection circuit that keeps your amplifier running safely,
even if you have all pairs of speakers playing at the same time.
TABLE OF CONTENTS
Introduction 1
Features and
Benefits 2
Installation
Considerations 3
Installation 6
Operation 9
Specifications 14
S
P EAKER
S
ELECTION
S
YSTEM
SS-4/SS-6
Speaker Selection
System
Balancing Speaker Volume
The volume control on your receiver or amplifier serves as the
“master” volume for all speaker pairs connected.
The volume level of the speakers may vary from room to
room. This is caused by several factors. Two lesser factors are
the size of the speaker and its efficiency. The largest factor is
the physical size of the room.
The best way to balance speaker volume is to equip each of
the speaker pairs in your system with a Niles volume control.
The controls allow you to adjust the volume of each speaker
pair individually. If all the speaker pairs in your system are
equipped with Niles volume controls, you can leave the ampli-
fier or receiver volume set at one position and use the Niles
controls exclusively.
14
SPECIFICATIONS
Audio Power Handling
100 Watts/channel
continuous music power
Frequency Response
+
0 dB,
-
0 dB (flat) from
20 Hz to 20 kHz
Mounting
Table-top component
Wiring Requirements
Individual runs of
2-conductor speaker
wire. Removable con-
nectors accommodate
wire sizes 14-22 gauge
(16 gauge
recommended)
Overall Dimensions
8-1/2" wide x 2" high
x 6-3/4" deep (SS-4); or
11-1/2" wide x 2" high x
6-3/4" deep (SS-6)
Weight
1-3/4 lbs (SS-4);
2-1/4 lbs (SS-6)
S
PEAKER
S
ELECTION
S
YSTEM
DS00359ACN/SS-4/SS-6 Printer 11/19/03 5:09 PM Page 1