Filter
Top Products
29
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 1-760-710-0992
16 CHANNEL, FULLY CONFIGURABLE POWER AMPLIFIERS
INSTALLATION CONSIDERATIONS
3-24 VOLT AC/DC OPTO-ISOLATED VOLTAGE TRIGGER - The Power
switch on the front panel must be in the “On” position for the voltage trigger to
function. When a Trigger Plug is inserted into the rear panel connector and the
sensing circuitry detects a voltage, the amplier is turned on. Once the Trigger
voltage is turned off, the sensing circuit instantly turns the amplier off. The
amplier is off when there is no 3-24V AC or DC voltage detected at the trigger
input. Voltage triggers can be supplied by Niles automated switchers, some
video projectors, some surround sound processors, or something as simple
as a 12 volt AC wall adapter plugged into the switched outlet of your stereo
receiver. Linear DC wall adapters are not recommended; the long discharge time
of the DC adapter’s lter capacitor will delay the turn-off of the amplier. Trigger
sources must be 3-24VAC or DC, 20mA or greater.
Allow a minimum of 2” of depth behind unit
to accommodate cables and connectors.
If the cabinet rear is not open to fresh air or if you’re
using low impedance loads, install two “boxer fans”
to provide continuous air ow into and out of the
cabinet.
If the cabinet rear is not open to
fresh air, install two small “boxer
fans” to provide continuos air ow
into and out of the cabinet
Make sure that there is a minimum of 5” of free air
space above the amplier and 3” on each side for
proper ventilation.
FIGURE 19 FIGURE 20