Filter
Top Products
You can control the loudspeakers bass output by placement. This is called the
boundary effect. You will get more bass response by mounting the OS loudspeaker
directly to a wall or other flat surface (any boundary close to the loudspeaker will
reinforce the bass frequencies). You can increase the bass output even more by
mounting the OS loudspeaker in a corner or under an eave (See Figure 5) This type
of placement gives the loudspeaker two boundaries, both reinforcing the bass
sounds. Of course, if you wish to hear less bass, try moving the loudspeaker away
from the boundary (See Figure 6).
Mounting Methods
The OS loudspeaker should be mounted horizontally. The bracket knobs will keep
the loudspeaker angled correctly in any position once they are tightened. You can
choose from three mounting methods to attach the OS loudspeaker to the wall,
ceiling, or other mounting surface.
1. If the loudspeaker is never going to be exposed to sudden accidental impacts,
wind, waves or earthquakes you can simply hang it on a nail using the nail
hole(s) on the bracket (See Figure 7).
2. The safest and most secure way to mount the loudspeaker is by screwing it to the
mounting surface using your own hardware (suitable for the surface you are
mounting to) and the bracket supplied with the loudspeaker (See Figure 7).
10
INSTALLATION CONSIDERATIONS
Figure 5
Placement for more bass output
Figure 6
Placement for
less bass output
DS00427ACN_OS_3Si.qxp 12/20/04 5:51 PM Page 9