Filter
Top Products
BAND SET
Z R . 6
Mu ltiZ o ne Recei v er
3
2
1
4
5
6
CD/DVD 0 1 0 : 0 0
Flat Panel Display
HT Receiver
DVD Player
Portable Docking Station
HT-MSU
12 V DC
Power Supply
Motorized Projection Screen
RS232 Controllable
Lighting System
Projector
Multizone Receiver with IR Interface
See Figure 7
TiVo
®
Flasher
12 Volt
RS232
Video Synch
CS12V
Figure 3. System Configuration 2
Remote
WS110
NILES AUDIO CORPORATION – 1-800-BUY-HIFI – 305-238-4373
9
SYSTEM CONFIGURATION 2
DUAL TV MODE AND INTEGRATION WITH AN IR CONTROLLED MULTIZONE RECEIVER
System Configuration #2 (Figure 3) demonstrates the Dual TV Mode feature of the iC2 System.
The flat panel TV is controlled via RS232 on the HT-MSU RS232 TV/7 port. This is considered the
default TV. The customer also has a projector and screen used only when the theater room is dark.
The projector is configured (programmed) with Niles QuickConfig PC Configuration Software to be
TV2 and is wired for IR control to the HT-MSU IR SRC1 port. The Status of TV2 is connected to the
HT-MSU IR SRC1 RCA connection using the 12V output of the projector (usually used to trigger the
screen). The projection screen is being triggered by the HT-MSU 12V Output #3. When the first Mas-
ter Key on the iC2 Remote is pressed from an all-off mode, the default TV (the flat panel TV, TV1)
is turned on. Master Key 8 is labeled SWAP TV. When the SWAP TV Master Key is pressed, TV1 (flat
panel) is turned off and TV2 (the projector) is turned on, and the screen is lowered for viewing. The
Dual TV Feature is not limited to IR controllable TVs. Either TV can be RS232 controllable.
NOTE: IN DUAL TV MODE, ONLY ONE TV IS ON AT A TIME. BOTH TVS CANNOT BE ON AT THE SAME TIME.