Filter
Top Products
NILES AUDIO – 1-800-BUY-HIFI – 1-760-710-0992
9
WWW.NILESAUDIO.COM
PAINTING ThE GRILLES
CM4PR loudspeaker grilles can be painted without priming, but the fabric scrim
must rst be removed. The installation template has die cut standoffs that can be
used to position the grille off the ground while painting. Use several light coats
sprayed from different sides and angles to cover all surfaces and not ll in any
holes. If you do ll some holes, use compressed air to open them before the paint
dries. It may be helpful to dilute the paint.
INSTALLING ThE GRILLES
The MicroThin™ speaker grille installs magnetically over the speaker. Carefully
center the grill over the speaker and let the magnets do their work, verifying that
the grill sets ush against the ceiling at all edges.
LOUdSPEAKER APPLICATIONS
The CM4PR Loudspeakers are designed to be installed in any standard ceiling
where larger, bulkier loudspeakers would not t. Additionally, their Rear Wave
Control enclosure will minimize sound bleeding through to adjacent rooms,
permitting even greater installation possibilities. While sold individuallly, optimum
sound coverage may be obtained by installing pairs of CM4PR loudspeakers .
When choosing a location, thought should be given to the sound coverage of the
loudspeaker, and ease of running the speaker wire.
LOUdSPEAKER APPLICATIONS (continueD)
SINGLE SPEAKER APPLICATIONS
CM4PR loudspeakers are ideal for small rooms where positioning two larger
loudspeakers is not practical. Examples would be a small kitchen, bathroom,
hallway, or small bedroom. Locate the loudspeaker as close to the center of
the room as possible for the most even distribution of sound (Figure 9). Avoid
installing the loudspeaker near a corner to prevent a “boomy” or diffracted sound.
Figure 9. Single Loudspeaker Application
9901197-RevA-CM4PR_Spk_Manual-V4.indd 8-9 8/17/11 10:11 PM