Niles Audio CM4PR Speaker User Manual


 
NILES AUDIO – 1-800-BUY-HIFI – 1-760-710-0992
5
WWW.NILESAUDIO.COM
INSTALLATION CONSIdERATIONS continueD
NOTE: BE VERY CAREFUL WHEN LOCATING THE SPEAKERS. VERIFY ALL LOCATIONS ARE
CLEAR OF OBSTRUCTIONS BEFORE CUTTING THE FIRST HOLE.
Each speaker requires two-conductor wiring of sufficient gauge. The gauge depends
on the length of the wire. For recommendations, please refer to (Figure 2).
When running loudspeaker wire inside walls or ceilings, use special jacketed
cable (CL-2 or CL-3 rating) to protect the wire and for  re prevention. In some
municipalities, conduit is required. For a trouble-free installation, low voltage wire
such as loudspeaker wire must be in accordance with the National Electrical
Code and any applicable provisions of the local building code. If you are unsure of
the correct installation techniques, wire jacket, or type of conduit to use, consult
a professional audio/video installer, building contractor, or the local building and
inspection department.
Figure 2. Speaker Wire Gauge Guide
Length of wire from speaker to amplifier Wire Gauge
Less than 80 feet
16
80 to 200 feet 14
More than 200 feet 12
PARTS GUIdE
PACKAGE CONTENTS – CM4PR
(1) CM4PR loudspeaker with Rear Wave Control enclosure, (1) Magnetically
attached round grill, (1) Hole template with painting standoffs, (1) Owner’s manual,
(1) Warranty card
INSTALLATION CONSIdERATIONS
Recommended tools for installation:
CM4PR
These require a 4-5/8”
(11.75 cm) diameter hole
opening with a minimum
of 3-5/16” (8.42 cm) depth
when measured from the
interior face of the drywall,
plus at least 5” (11.75 cm)
clearance to one side of
the loudspeaker opening
for the Rear Wave Control
enclosure. To the sides of
the hole you will need 1”
for the mounting tabs to
clamp the speaker to the
drywall.
(CONTINUED ON NEXT PAGE)
• Cordless screwdriver • Measuring tape • Painters tape
• One inch #2 Phillips tip • Stud fi nder • Drop cloth
• 1/8” Drill bit • Spackle • Rubber gloves
• Drywall saw • Wire stripper • Optional - a 24” x 24”
piece of R19 insulation
• Laser plumb bob • Cable ties
• 12” -14” Coat hanger wire • Pencil
Figure 1. CM4PR loudspeaker installation dimensions
3-5/16” (8.4 cm)
Depth Behind
Drywall
CM4PR 4-5/8” (11.75 cm)
Diameter Hole Opening
5” (12.7 cm)
Clearance
9901197-RevA-CM4PR_Spk_Manual-V4.indd 4-5 8/17/11 10:11 PM