Filter
Top Products
INSTALLATION
5
To ensure years of enjoyment from your NADY AUDIO MXE-612 mixing console, please read and understand this manual thoroughly
before using the unit.
1. INSPECTION
Your NADY AUDIO MXE-612 was carefully packed at the factory in packaging designed to protect the units in shipment. Before
installing and using your unit, carefully examine the packaging and all contents for any signs of physical damage that may have
occurred in transit.
[Please note: Nady Systems is not responsible for shipping damage. If your unit is damaged, do not return to Nady, but notify your
dealer and the shipping company (if shipped to you) immediately to make a claim. Such claims must be made by the consignee in a
timely manner.]
2. RACK MOUNTING
The MXE-612 can be rackmounted with the optional RMK-612 rackmount kit which can be ordered from your dealer or through the
Nady Service Department (see back page).
3. SETUP AND OPERATION
Parts of the unit can become very warm during use. This is normal during operation. Care should be taken to ensure that there is
enough space around the unit for cooling. Also, do not place the MXE-612 on high temperature devices such as power amplifiers, etc.,
or the unit may overheat in operation.
Although the unit’s chassis is shielded against radio frequency (RF) and electromagnetic interference (EMI), extremely high fields of RF
and EMI should be avoided.
The MXE-612 is designed to operate with the supplied external power supply unit (PSU). Please make sure that the power unit
supplied is marked for the correct voltage in your area (120VAC/60 Hz or 230VAC/50 Hz). Power requirements for electrical equipment
differ from area to area. In new installations and portable sound systems, or any situation in which the AC power is in question, it is wise
to confirm the voltage and use the appropriate power supply unit before connecting it to power sources.
Europe (except UK): 230V, 50Hz
UK and Australia: 240V, 50Hz
USA and Canada: 120V, 60 Hz
For other areas, please check with local authorities.
When ready to operate, plug the AC cord into the power source. Make sure that the unit is turned off before connecting to the AC power
source to avoid possible loud transients which can damage your speakers or your ears, especially when monitoring with headphones.
Set the noted controls to the positions indicated below to further minimize the chance of undesired noise when first powering up your
MXE-612 :
GAIN FADERS (8/33) .................................................................................................................................................... SET TO MINIMUM
HI, MID & LOW EQ’S (4) AND PAN/BALANCE CONTROLS (6/14) ............................ TURNED TO THE CENTER DETENT POSITION
AUX/EFF CONTROLS & PHONES LEVEL CONTROLS (5/20) ................................. TURNED COMPLETELY COUNTERCLOCKWISE
ALL OTHER CONTROLS SHOULD ALSO BE TURNED COMPLETELY COUNTERCLOCKWISE
Power up the unit as noted in Power Connections, Indicators, and Switches (Section 3e in CONTROLS AND CONNECTIONS,
page 11).