M&S Systems WG150W Speaker User Manual


 
tweeter when removing the paint mask in
order to prevent any damage. Attach the
speaker cable to the speaker by pressing down
on the red (+) or black (-) gold-plated push
terminals and inserting the red wire in the red
terminal and the black wire in the black terminal.
See Figure 3. Make sure that none of the strands
from the black and red wires are touching each
other. This can create a short circuit that can
damage your electronics. Index the mounting
tabs to make sure that all tabs will clear the
opening. Insert the speaker in the ceiling and
tighten the tabs with the screws on the front of
the grille. DO NOT OVERTIGHTEN THE
SCREWS, the screws should only be tight
enough to secure the speaker.
Step 6. After the speaker is mounted,
adjustments to the swivel tweeter (small speaker)
can be made by either directing the sound
visually or by using a musical source to
determine the best sound coverage for the
listening area. To position the tweeter, press at
the outside edge of the tweeter housing
(DO NOT
PRESS DI-
RECTLY ON
THE TWEETER
CONE ).
Note (see
figure 4) the
crease in the
asymmetrical
tweeter
provides the
Page 9
FIGURE 4
Crease position
tweeter
horn
115986D.pdf 9115986D.pdf 9 11/16/2005 10:54:35 AM11/16/2005 10:54:35 AM