M&S Systems WG150W Speaker User Manual


 
Do not install the actual speaker until the wall
board is in place. Until then leave several feet
of wire secured to the back of the mounting
ring. The excess wire can be removed during
final installation.
During the drywall installation, make sure the
speaker cut-out hole does not extend farther than
1/4 inch from the inside of the mounting ring. The
flat rough-in rings and flaps are thin enough that
they won’t interfere with installation.
Step 2. After you have determined the speaker
locations using the guidelines above, secure a 16
gauge 2 conductor cable to the mounting ring
tabs (see figure
9), such as the
M&S Systems
MS16X, for at-
tachment to the
speakers after the
dry wall has been
installed. Leave at
least 18 inches
additional cable
for the connection
during final
speaker installa-
tion. Run the
other end of the
speaker cable to
the audio source.
NOTE: Make a drawing of each speaker location.
This will assist you in locating the wires that have
been covered after the sheet rock has been
installed.
Page 12
FIGURE 9
115986D.pdf 12115986D.pdf 12 11/16/2005 10:54:35 AM11/16/2005 10:54:35 AM