Filter
Top Products
4
Mr. Heater | Gas-Fired Low-Intensity Infrared Heater Operating Instructions and Owner’s Manual
- Rear View -
Rear Movable Hanger
Heat Exchanger
Reflector
Front Fixed Hanger
About The Heater
Burner Box
Control Side
Access
Burner Box Contains the electrical components (i.e. blower motor, power transformer, etc.) and gas distribution components
(i.e. gas valve, etc.) that make the heater work. There are no owner serviceable items contained in this box.
Front Fixed Hanger Provides rigid support and mounting surface for the reector. Holes are provided in the upper corners of the
bulkhead to accommodate suspension hardware required for installation of the heater.
Reector The reector is made from formed aluminum and reects the radiant energy downward to the space to be
heated.
Heat Exchanger A U-shaped tube through which the heated products of combustion pass.
Rear Movable Hanger Provides support for the heat exchanger and reector at the end that is furthest from the burner box. The
support may be moved (within limits) to accommodate hanging of the unit.
Service Door To be removed only by a licensed contractor. Removal of this service door provides access to the electrical and
gas distribution components.
Intake Vent Accomondates a 3" diameter combustion air inlet duct that delivers fresh air to the burner.
Exhaust Vent Accomondates the air-venting duct that carries the products of combustion to be vented outdoors.
Nipple – ½ NPT Point at which the gas supply is connected to the heater.
Power Cord Includes a three prong plug that must be connected to a dedicated and properly grounded three prong ceiling
outlet.
Exhaust Vent
Intake Vent
1/2" NPT
Power Cord