Filter
Top Products
HOOKUP INSTRUCTIONS
STEP 1 Amplifier to Speaker Selector Hookup (Using Pre-Terminated Speaker Cable)
IMPORTANT NOTE
Your Monster Multi-Speaker Selector is designed to accept any size cable terminated with Monster
®
Angled Gold Pin
®
connectors and up to 14 gauge non-terminated speaker wire. If you’re using non-terminated speaker wire, do not use
any speaker wire that is larger than 14 gauge. The lower the gauge number, the larger the cable (e.g., 12 gauge is larger
in actual physical size than 14 gauge).
The following hookup instructions are based on usage of pre-terminated cable (connectors are already attached
to the speaker wire). Non-terminated stranded conductors can frey and cause electrical shorts, and may not provide
maximum signal transfer.
If you have unterminated speaker wire, terminate it on both ends with push-pin (aka "tip") connectors before hooking up
your amplifier to your multi-speaker selector. For maximum conductivity, signal transfer and corrosion resistance,
we recommend terminating your speaker cable with Monster 24k gold contact Angled Gold Pin connectors.
3