Filter
Top Products
10
TROUBLESHOOTING GUIDE
PROBLEM - One of the speaker pairs hooked up to the Monster Multi-Speaker Selector isn't working.
Possible Cause #1
You haven't pushed the speaker selector button on the front panel of your Monster Multi-Speaker Selector
that corresponds with correct speaker terminal on the back panel. For example, if you push the Speaker 2
selector button, that will only select the speaker pair properly hooked up to the speaker terminal labelled Speaker 2.
Possible Solution
• Push the speaker selector button on the front panel of your Monster Multi-Speaker Selector that corresponds
with the correct speaker terminal on the back panel.
Possible Cause #2
You have improperly hooked up your speaker cable to the corresponding speaker terminal.
Possible Solution
• Turn on your amplifier or receiver..
Possible Cause #3
Your amplifier or receiver is not turned on
Possible Solution
• Make sure your amplifier or receiver is plugged into a properly grounded 120V wall outlet.
• In some households, a wall switch may need to be thrown to make the wall plug come alive.
Try turning on the light switches located near the wall unit powering the Amplifier or Receiver.