Filter
Top Products
SS-150THX satellite speaker
page 4
FIGURE 1
USING THE SS-150THX MOUNTING BRACKET
Most users will set the speaker to a single mode for all playback, and we recommend that the choice be made
based upon room conditions. Still, some users may prefer the Dipole mode for some material and the Tripole mode
for other material. If you have questions regarding this, please contact your M&K dealer or the M&K factory.
4. INSTALLATION OF YOUR SS-150THX SPEAKERS
Your M&K SS-150THXs can be installed in a variety of ways. Choosing the correct location, however, is important.
READ SECTION 6 (page 7) BEFORE DECIDING WHERE TO INSTALL YOUR SS-150THXs.
They can be placed on tall stands (M&K ST series); shelves or bookcases; or more permanently mounted using
brackets or a ceiling suspension system. To make their installation as easy as possible, we have provided an integral
flush-mount bracket that allows you to install the SS-150THX quickly and securely. Integral mounting hardware is also
provided for an Omnimount 50 series mounting bracket. Remember that when the speaker is installed above the
listeners' heads, the tweeter should be at the bottom.
Your SS-150THX speakers have one flush-mount wall bracket attached to each cabinet, mounted on the side that
sits against the side wall. Also enclosed is a kit consisting of two matching brackets that attach directly to the wall,
as well as all necessary mounting screws and drywall inserts.
In order to use these brackets, see Figure 1 and the enclosed template, and then follow these instructions. The
initial step is to determine where you will locate your SS-150THXs. See Section 6 (page 7), for guidelines on where
to locate the speakers. Then, using the template sheet enclosed (which is reproduced below), mark holes on the wall
where the brackets will be permanently mounted. We strongly recommend that the bracket be mounted into a wall
stud. This will provide the most secure mounting. When locating the mounting holes into the stud, first locate its center.
Please use the separate enclosed sheet to mount the speaker to the wall. The reproduction of the sheet
that appears below is not to scale and is reproduced only for reference.