Filter
Top Products
8 9
General information
Loudspeaker
maintenance
Use the supplied cloth to polish dust and
fingermarks from the speakers. Rub the
surface to be cleaned with the inner cloth.
Remove tarnish and buff to a high shine with
the dark outer cloth. Do not use spray
polishes or solvent cleaners as these may
damage the highly polished multi-layer
lacquer finish. If necessary clean the speaker
grilles carefully with a soft brush.
Product
service
Should a fault occur with your loudspeakers
please pack them correctly, using the
original packaging.
Product for service should be returned to the
appointed dealer from whom you
purchased the product. If you experience
difficulties or there is no Mission dealer in
your area, contact the Mission distributor for
your country or the main service centre for
your region.
Important
Notice
to
UK
Users
–
e8as1, e8as2
The power cord on your Mission powered
subwoofer is supplied with a plug
incorporating a fuse, the value of which is
indicated on the pin face of the plug. Should
the fuse need to be replaced, an ASTA or BSI
approved BS1362 fuse must be used of the
same rating. If the plug is cut off it must NOT
be re-used. Dispose of any such plug safely.
There is a danger of electric shock if a cut-off
plug is inserted into a mains socket.
The wires in the mains lead are coloured in
accordance with the following code:
Blue - Neutral: Brown - Live.
As the colours of the wires in the mains lead
may not correspond with the markings
identifying the terminals in the replacement
mains plug, proceed as follows:
The wire coloured Blue must be connected
to the terminal marked with the letter "N" or
coloured Black. The wire coloured Brown
must be connected to the terminal marked
with the letter "L" or coloured Red.
Recommended Amplifier:
50 - 150 W 50 - 150 W 50 - 150 W 50 - 200 W
Enclosure: 2-way sealed box 2-way sealed box 3-way reflex loaded 2-way ABR loaded
Frequency Response ±3dB: 80 Hz - 30 kHz 80 Hz - 30 kHz 48 Hz - 30 kHz 44 Hz - 30 kHz
Sensitivity SPL/M @ 2.83V: 85 dB 90 dB 90 dB 90 dB
Impedance: 8 Ohms compatible 8 Ohms compatible 8 Ohms compatible 8 Ohms compatible
(minimum 4.0 Ohms) (minimum 4.6 Ohms) (minimum 4.0 Ohms) (minimum 4.0 Ohms)
Bass: 110 mm Paramid-S Twin 110 mm Paramid-S 4 x 110 mm Paramid-S Twin 165 mm Paramid-S
Mid: - - 110 mm Paramid-S -
Treble: 25 mm Viotex-S 25 mm Viotex-S 25 mm Viotex-S 25 mm Viotex-S
Effective Volume: 3.75 litres 5.75 litres 23 litres 40 litres
Dimensions (H x W x D): 284 x 160 x 250 mm 403 x 160 x 250 mm 956 x 300 x 334 mm 1108 x 330 x 360 mm
11.2 x 6.3 x 9.8 inches 15.9 x 6.3 x 9.8 inches 37.6 x 11.8 x 13.2 inches 43.6 x 13 x 14.2 inches
Weight: 6 kg 8.7 kg 19.7 kg 22.1 kg
13.2 lbs 19.2 lbs 43.4 lbs 48.7 lbs
e80 e81 e82 e83
Specifications
Recommended Amplifier: 50 - 150 W Integrated 350 W Integrated 500 W
Enclosure: 2-way sealed box ABR loaded sealed box
Frequency Response ±3dB: 80 Hz - 30 kHz 36 Hz - 150 Hz 28 Hz - 280 Hz
Sensitivity SPL/M @ 2.83V:
90 dB - -
Impedance: 8 Ohms compatible
(minimum 4.6 Ohms)
Bass: Twin 110 mm Paramid-S 250 mm + twin ABR 4 x 210 mm
Mid: ---
Treble: 25 mm Viotex-S - -
Effective Volume: 6.5 litres 30 litres 46 litres
Dimensions (H x W x D): 172 x 443 x 250 mm 415 x 365 x 400 mm 430 x 400 x 560 mm
6.8 x 17.4 x 9.8 inches 16.3 x 14.4 x 15.7 inches 16.9 x 15.7 x 22 inches
Weight: 9.1 kg 17.3 kg 32 kg
20.1 lbs 38.1 lbs 70.5 lbs
e8c e8as1 e8as2
Specifications
Mission reserves the right to change specifications without notice. E & OE
Warning:
When an amplifier is driven beyond its power output capabilities it will produce distorted results which will
quickly damage your speakers by overheating. Make sure that your amplifier is not left unattended when playing, for
example at parties, and turn the volume control down at the first sign of audible distortion.
CORD GRIP
FUSE
BROWN
(LIVE)
OUTER
SLEEVE
BLUE
(NEUTRAL)