Filter
Top Products
6
owners manual
USING THE SYSTEM
Your OmniVibe digital music system is ready to go as soon as you plug it in. Simply set your
iPod to play what you want and insert it into the dock on the front of the system.
• You should hear the music immediately. If you do not, refer to “Troubleshooting”.
• The + and – buttons on the dock allow you to adjust the system volume.
• Whenever your iPod is docked in the system, it recharges (until fully charged).
• The system will go into standby after 10 seconds when there is no audio input.
The LED indicator will flash slowly during standby.
TV OR VCR CONNECTION FOR IPOD PHOTO
The MIRAGE OmniVibe includes a pass-through video feature that allows you to display photos
from your iPod photo onto a television set while the iPod photo is docked to the OmniVibe.To
connect the OmniVibe to a television set or VCR, follow the steps below:
1. Make sure the power to your television set or VCR is turned off.
2. Locate a Composite (RCA) cable (sold separately).
• Connect one end of the Composite (RCA) cable to the Composite (RCA) port on the back of
the OmniVibe system and the other end to the yellow Composite (RCA) input on your
television set or VCR.
Note that video cannot be displayed on both the iPod and the Television at the same time
USB FUNCTIONALITY
The USB port allows your iPod to interact with iTunes while docked. Simply connect the
OmniVibe to your computer via a USB-A to USB-B cable (not included).This is a standard USB
printer cable.